Banner Specific Artwork Guidelines
- Provide Artwork at 100% final size
- 25 mm internal bleed is needed on each edge is recommended
- 25 external bleed is needed on each edge (50mm total to each dimension) for banner hemming
- Example - A 1000mm x 1000mm banner supplied as 1050mm x 1050mm with bleeds

Pull Up Banner Artwork Guidelines
- Provide artwork at 850mm x 2100mm
- Visible artwork area is 850mm x 2000mm
- Include 10mm internal bleed at the top (to feed into head - not seen)
- Include 90mm internal bleed at the bottom (to feed into stand - not seen)

Standee Artwork Guidelines
- Please have die-line as a stroke on a separate layer named 'Thru-cut'
- We only offer 2 strut sizes on the rear so your artwork must accommodate these area's
- 260mm wide x 1400mm high
- 320mm wide x 1600mm high
- Please see general artwork guidelines for any other consideration not outlined

Shelf Wobblers Artwork Guidelines
- Please have die-line as a stroke on a separate layer named 'Thru-cut'
- Please have stem at the top of wobbler at least 70mm wide if you would like 50mm tape - tape will be applied to print side of stem unless otherwise directed
- Shape of wobbler must be a simple shape of a square, circle, diamond or rectangle + the stem
- Please see general artwork guidelines for any other consideration not outlined